Non-Adjustable Flow Monitor
LPH Series

For economical monitoring of flows of corrosive
and non-corrosive liquids and gases.
 
 

Water Lift Stations
Biomedical Instrumentation
Cooling Systems

Compact Size,
Most Economical,
Close On/Off Differential

Gas or Liquids

Fixed

Air 50 - 45,300 SCC/M
(0.105 - 95.99 SCFH)
Liquid 1 - 2200 SCC/M
(0.01590 - 34.980 GPH)

80, 100, 1500, 3000 PSIG
(5.52), (6.8), (103.4), (206.8) BARG

Acrylic, Brass, Teflon®,
316 Stainless Steel

1/8", 1/4" FNPT

Operation

As flow is established upward through the unit and continues to increase, the pressure differential across the grooved magnetic piston increases until it overcomes the small piston's resistance (mass). The force causes it to progress fully upward which actuates the dry reed switch. This is a snap action and occurs in the decreasing mode as well.

  • Actuation points for air at 68° F and 14.7 PSIA with increasing flow.

  • Deactuation (decreasing flow) averages 10% less than actuation (increasing flow).

  • Flow Setting accuracy ± 10% of actuation points shown

  • Repeatability ± 1%

  • Unit will pass greater flows.

  • Teflon encapsulated piston not available in 375-4 or -5

Corrections must be made for other gases, line pressure and temperatures. Please consult your representative or the factory.

Calibration Range
MODEL AIR SCC/M (SCFH) WATER ML/M (GPH) PORTS
FNPT
LPH-125-0 50 (0.105) 1 (.016) 1/8"
-1 120 (0.254) 2 (.03171)  
-2 560 (1.187) 16 (.25369)  
-3 750 (1.589) 30 (.47567)  
-4 1300 (2.755) 45 (.71350)  
-5 1400 (2.966) 50 (.79278)  
-6 1900 (4.026) 65 (1.0306)  
-7 2500 (5.297) 85 (1.3477)  
-8 2700 (5.721) 90 (1.4270)  
-9 3300 (6.992) 105 (1.6648)  
-10 3600 (7.628) 120 (1.9027)  
-11 5200 (11.02) 170 (2.6955)  
-12 6000 (12.71) 200 (3.1711)  
LPH-250-1 350 (0.742) 7 (0.111) 1/8 "
-2 6000 (12.71) 200 (3.171)  
-3 7500 (15.89) 250 (3.964)  
-4 9500 (20.12) 315 (4.994)  
-5 10500 (22.25) 346 (5.486)  
-6 12500 (26.49) 400 (6.342)  
-7 15200 (32.21) 500 (7.928)  
-8 24000 (50.85) 760 (12.05)  
LPH-375-1 3000 (6.36) 70 (1.110) 1/4"
-2 15200 (32.21) 475 (7.531)  
-3 30300 (64.20) 950 (15.06)  
-4 37000 (78.40) 1425 22.59)**  
-5 45300 (95.99) 2200 (34.88)**  
Pressure Loss Table
DP AT SET POINT
MBARS (INCHES OF WATER)
ALL UNITS 11.2 (4.5)
Corrections must be made for other gases, line pressures and temperatures. Please consult your representative or the factory.

 



Kalrez® and Viton® are registered trademarks of DuPont Dow Elastomers..
Teflon® is a registered trademark of E. I. du Pont de Nemours and Company.

Home - About - Products - Distributors - Contact

© CTE Chem Tec -
Designed and Hosted by ABC Web Service